GENERAL BOATING WATERSPORTS & BOATS SEATING COVERS/TOPS MAINTENANCE ELECTRICAL HARDWARE PLUMBING PROPS & ANODES FUEL ELECTRONICS & NAVIGATION SAFETY TROLLING & FISHING ANCHORING/ MOORING TRAILERING PAINT VENTILATION FASTENERS STEERING ENGINE ITEM NUMBERS IN RED ARE HAZARDOUS ITEMS IN BLUE ARE NEW D SEA VALUE Y OVERSIZED GCOURIER SURCHARGE SECTION 789 ELECTRICAL Continuous duty solenoid. Insulated, with steel housing. Normally open contacts, one circuit: Off/On. 85A continuous. 12V SPST SOLENOID Item# Volts Amps Qty List 12-24059BP 12 85 Retail 78.02 EA Insulated. SPST, normally open. One circuit: Off/On. Continuous duty: 65A at 12V DC. Bracket mounting holes 5/ 16" x 19/ 32" on 213/ 64" centers. Copper contacts. Copper terminals 10-32 thread and 5/ 16"-24 thread. Hex nuts and lock washers included CONTINUOUS DUTY SOLENOID Item# Volts List 12-2405908BP 12 90.43 EA Item# Volts Amps List 12-24200BX 12 110 186.19 EA Single pole, single throw (SPST). 5/ 16"- 24 / 10-32" hex nuts and lock washers included. Plated steel housing and copper contacts. LATCHING SOLENOID Switched Solenoid Item# Volts Rating Replaces List 969-1002203 12 65A CH 24059-08 77.18 EA 969-1002204 12 85A CH 24059 67.38 EA Remotely switch high amperage loads with a low amperage on-off switch. • Copper #10-32 ignition and ground terminals • Copper 5/ 16"-24 contact terminals • Plated steel case, copper contacts • Hex nuts and washers included • Bracket mounting holes 5/ 16" x 19/ 32", 213/ 64" on centers • UL and CE approved CONTINUOUS DUTY SOLENOID Remotely switch high amperage loads with a low amperage on-off switch. • Intermittent rating 100A: 10 seconds • Copper #10-32 signal terminals • PVC coated steel case • Copper 5/ 16"-24 contact terminals • Bracket mounting holes 5/ 16" x 19/ 32", 2 13/ 64" on centers • UL and CE approved PVC COATED CONTINUOUS DUTY SOLENOID Item# Volts Rating Replaces List 969-1002205 12 85A CH 24117-01 89.08 EA Item# Volts Replaces List 969-1002206 6-12 CH M-200 58.09 EA Intermittent switching of high amperage loads with a low amperage on-off switch. • #10/32 signal terminals • Signal voltage 12V DC and contact voltage 6-12V DC • Copper 5/ 16"-24 contact terminals • Bracket mounting holes 5/ 16" x 19/ 32", 2 13/ 64" on center • Rated at 750A make/100A break, this solenoid is for intermittent use only: 10 seconds ON, 20 minutes OFF (ideal for engine cranking) INTERMITTENT DUTY SOLENOID Item# Volts Rating Replaces List 969-1002201 12 75A CH 24450 130.18 EA Two solenoids in one saves money and simplifies wiring. Provides braking dynamic capability for permanent magnet motors when coils are not energized. • Rated at 75A make and break at 12V • DPDT intermittent duty • Comparable to Cole Hersee #24450 MOTOR REVERSING SOLENOID
RkJQdWJsaXNoZXIy MTI2MTky